Inspector Technician at Amtec Enterprise - 1

Job DescriptionJob DescriptionTitle: Inspector TechLocation: Irvine, CAShift 1st 5AM-1PMPay Range: $31.10 - $46.70/HR, Depending on experience and interview outcome,. No wage is guaranteed.POSITION SUMMARY:With minimum guidance in a team environment, using independent judgement to determine quality and usability, responsible for a wide variety of complex inspection requirements.RESPONSIBILITIES:Responsibilities may include some or all of the following:Maintain accurate and uptodate acceptance and rejection records and/or certifications systems as required by the applicable specifications.Determine acceptance or rejection after inspection and/or calibration of parts, tools, instruments or xray film. Identify defective conditions and test failures and prepare all appropriate documentation and/or calibration history.INSPECTIONPerform inspection on complex parts using a wide variety of measuring and test equipment.Adapt and develop complex inspection setups to check sample parts, forgings and castings. Check tool and jig layouts.Perform first article and envelope inspections, source inspections, and/or complex surface plate setups.Interpret specifications, charts, manuals and other data to arrive at acceptance or rejection. Recommend changes to supervision. Use mathematics to convert blueprint dimension and tolerances. Work within the guidelines of drawings, schematics, blueprints, route sheets, travelers, quality directives, technical engineering specifications, customer's requirements and military standards.Layout all component part characteristics onto rough or semimachined castings, forgings and machine parts to maintain control of machining cycle during manufacturing.Make own gaging setups on surface plate using block, parallels, clamps, sine plates and Vblocks to take readings with precision measuring instruments.Adapt inspection equipment to check standard, nonstandard and special products.Investigate cause of customer return failures. Perform inspections to applicable specifications within assembly, test and shipping departments. Assist customer/government source inspectors as necessary.CALIBRATIONPerform calibration on complex multifunction electronic measuring and test equipment.Setup calibration test conditions having various circuit requirements interpreting calibration procedures, specifications, manufacturer's instructions, or related documents.Ability to interpret drawings and electronic schematics.Document and evaluate historical data to determine calibration intervals. Diagnose and calibrate newly acquired complex electronic equipment.NONDESTRUCTIVE TESTPerform daily, weekly and monthly equipment and material checks. Perform preinspection and postinspection cleaning.Setup equipment and conduct tests.Interpret, evaluate and document inspection results in accordance with approved procedures.Perform complete inspections in accordance with applicable specifications, standards and other contractual documents.Operate Xray equipment and film processor.Select the method and technique to be used for a specific inspection. Prepare and verify the adequacy of inspection procedures.Approve procedures, specifications, standards and other written documents that control the inspection. Conduct or direct the training and examination of Level I, II and III personnel.Observe all prescribed safety rules and regulations and maintain a FOD free work area. Perform other related responsibilities.Job Requirements:Five years related inspection experience or demonstrated ability to perform described responsibilities. Knowledge of applicable military standards or specifications.Required experience in CMM operations, background in dimensioning and tolerancing per ANSI Y 14.5.Proficient in reading and interpreting blueprints, customer's specifications and internal drawings and procedures.Thorough knowledge of machine shop mathematics including trigonometry. Knowledge of electrohydraulic servo systems and the computer IEEE systems. Personal hand tools may be required.May be required to lift up to 50 lbs.Must demonstrate effective verbal, written and communication skills. Ability to work effectively with others and be a participative team player.