QC Inspector at Omega EMS

Job DescriptionJob DescriptionSummary:QC Inspector will perform inspection and determine compliance of partially or fully completed printed circuit assemblies to defined acceptability standards. Essential Duties and Responsibilities: Ability to complete PCB & PCBA level inspections competently. Scan boards inspected in the data collection system. Raise and review Technical Inquiries for any discrepancies as observed. At the end of the shift, make sure the working areas are clean. Escalate all issues to Supervisor / Engineer / Manager. If matters are unresolved, notify the Quality Manager immediately.Attend training as identified and implement all procedures pertaining to QMS, Be able to associate defects to workmanship standards specified by IPC (class 2 and 3) as well as custom requirements. Recommend opportunities for improvement.Read and understands Omega Quality Management System (QMS)Read and understands Omega Quality PolicyFill out any appropriate forms or records as requiredComplete all other duties as assigned by management.Other duties may be assignedMinimum Qualifications More than 5 years working in an electronics inspection environment within the CM or similar environment. Previous IPC-A-610 or J-STD-001 experience preferred. Must possess good working knowledge of CM technology (specifically circuit board assembly)Ability to read, write and communicate effectively in English to the degree necessary to perform the job. Knowledge of industry standard workmanship requirements (IPC-A-600 / IPC-A-610) Ability to visually verify fine detail work.Ability to understand and follow directions inspecting printed circuit assemblies (PCA’s).Proficient at reading and interpreting blueprints, drawings, bills of material, etc.Basic competence with MSWord, Excel and Outlook (or equivalent preferred) Ability to work under pressure and prioritize tasksMust be able to sit for long periods of time conducting work while looking through a microscope or other magnification device. Skills Possess and demonstrate good team relations skills Demonstrated ability to follow instructions and achieve goals and tasks7am to 3:30pm