Re-Cutter 2 at Staff on Site

All the items listed below are to be followed by the Line 8 Winder Operator. This is a detailed list of what your job is and what is expected of you as an employee. Primary responsibilities should take place before secondary responsibilities unless otherwise instructed. Primary Responsibilities Read work orders. Check equipment before operating (Blades, Tooling ). Set up machine for the current job. Change blades throughout production when cuts start to go bad. Make a notice when blades are running low. Tag boxes correctly and fill out load tags for what product is going on that specific pallet. Keep production running smoothly. Replace boxes right after they fill. Build boxes while waiting for the machine to fill the current one. Keep a clean and organized area. All other assigned duties Secondary Responsibilities Sweep around machine. Blow out the inside and underneath the machine. Physical demands: Standing : Prolonged periods of standing on production floor (up to 8-10 hours per shift). Walking : Frequent walking around production and packaging areas. Lifting : Occasionally lift and move products or materials up to 25-50 lbs. Bending/Stooping : Regular bending to inspect lower-level machinery or products. Reaching : Frequent reaching over and around equipment or conveyors. Climbing : Occasionally climb steps or ladders to access equipment or inspection points. Repetitive Motions : Repetitive hand and arm movements when conducting tests or entering data.